A ball faucet is a common type of faucet used in kitchen sinks. It is single-lever, usually with a narrow body and a crank that allows smooth movement in all directions. Inside her body is a plastic or metal sphere that controls the flow of water. Leaks in this type of faucet usually occur when the outside becomes loose or when the inner rings or meet our team.
Circle or rubber valve wears out. The ball is rarely the cause of the leak, but you can replace it if it is visibly damaged.
Step 1
Tighten the outside of the faucet, if applicable, using channel pliers. Wrap the plier’s teeth with tape to avoid scratching. A loose faucet can result in a leak. If the leak. Don’t stop; proceed to the next step.
Step 2
Stop water access to the faucet by closing the valve under the sink. Loosen or remove the adjustment screw or fastener securing the handle to the faucet body and using an Allen wrench or other tool. Proper. Pull off the handle and set it aside.
Step 3
Release the outside and remove it from the faucet body. Pay attention to the direction and location of each internal part of the faucet body before removing them; this is necessary to later assemble it back with the pieces.
In the right places. Take out the plastic and rubber chamber and remove the ball. Check if it is damaged. Carefully remove the two valves and springs using a small screwdriver.
Step 4
Pull the spout off the faucet body and remove the “O” rings around the outside of the body.
Step 5
Purchase a faucet repair kit with new “O” rings, new valves and springs, as well as other rubber tubes; bring the old faucet parts to the store to buy identical parts.
Step 6
Apply waterproof and temperature-proof grease to the rings and place them in place on the faucet body. Reassemble the faucet using the new parts. Slowly open the water valves and test the faucet.
How To Fix A Leaky Faucet In 6 Simple Steps?
For the water consumption to be as little as possible, periodic maintenance on your faucets should be carried out. Repairing a leaky faucet is a very common problem, but after reading ours. Step-by-step, you will find that it is also a very easy problem to solve. It doesn’t matter if your faucet has separate handles for hot and cold water or just one for both, every faucet. It works according to some basic principles. See in 6 steps how simple it is to fix your leaky faucet and never waste water again.
Shut Off The Water Supply
Shut off the water supply and remove the faucet handle by loosening the small screw at the top or back of the handle. Once you remove the cover, you will see the screw installed in part. Top of the handle. If necessary, use penetrating oil to help disassemble it.
Remove The Packing Nut
Carefully remove the packing nut with good-sized pliers or adjustable wrench to not leave marks on the metal. Twist the stem or spindle by turning it in the same direction as you would turn on the faucet.
Remove The Screw That Holds The Seal.
Remove the screw holding the seal. If necessary, use penetrating oil to loosen the bolt. Check bolt and stem, and replace if damaged.
Replace Old Seal
Replace the old seal with a new one. Some seals will work for both, but you must be sure to purchase the exact replacement parts.
Fit The New Washer
Fit the new sealing washer onto the stem and reinstall the assembly into the faucet. Rotate the rod clockwise.
Release The Water Supply
Replace the handle and screw cap. Release the water supply and check if leaks continue.
Ready!
Water leaks can cost a fortune. Needlessly, just one drop per second wastes about ten thousand liters of water a year. Most leaks are easy to fix. Try to visit the website. There is no point in keeping the waste since repairing a faucet costs very little to the cost generated by wasting water.
